-the use of 1.5"x1.5"x3" rectangular tube as main support beams running the length of the car
-intersecting pipes, where 1.5" OD circular pipe goes through the rectangular tube, and is then welded on all edges for a VERY strong joint.
-48" of shoulder width, more than plenty comfortable for two people.
-53" of leg room.
-long suspension wishbones for smooth travel.
-front crash zone (an area of pipes and tube that will absorb energy in the front of the car)
-tri-supported roll bars
-the use of gusset plates in areas where intersecting joints are not used
-a hard top (although not yet designed) appears likely as an option
so hopefully, this will be it. a final design. the frame appears as though it would support a very angular, sharp body style. check it out, let me know what you think
No comments:
Post a Comment